HELP HELP cant get air out of loop

B

blair

New member
Hi,

Ive done about 4 loops and this one just wont bleed the res is a xspc dual bay res for a D5 pump, however who ever designed the res needs to be shot it has a pit of plastic tubing inside directing the intake to the pump which means air gets pumped back round again and its a continuous cycle i cant get any of the air to budge and have 2 bits of hose without any water in its just trickling through them like a stream!
 
What have you done to bleed the loop?

Rocking the case usually does the trick. Keeping the res open also helps, but you could always loosen the bleed screw on the rad to really help.
 
ive turned the case all around led on side, top bottom, other side i can get the air out its just the pump shoots it back in
 
How long have you been bleeding the air out? Do ou have two d5 pumps in the loop as well? Any photos of your set up also could help :)
 
Just use
 
k no need to images i think now i think we may be winning all massive pipe wide bubbles are gone only a few small remaining this has taken me 7 hours so far i took 1 hour on alast loop i only added another gpu block and now takes this long!
 
I've had a similar issue with mine before. It just takes time and patience to get it all out. I've even pinched the tubes a bit to get the water to build up in the air pockets then released it to get the water flowing while tilting every which way and adjusting flow speed with pump sometimes its a real nightmare. When I use my D5 rez as a dual loop instead of single I dont have the bleed issues.
 
You must log in or register to reply here.

Similar threads

AlienALX
Newish rig sorta kinda maybe.
2
Replies
38
Views
7K
Bartacus
B
Dicehunter
Black and white Rig
2 3 4
Replies
64
Views
23K
Dicehunter
Dicehunter
Mr. Smith
Can you get me out of the dog house?
Replies
6
Views
5K
Mr. Smith
Mr. Smith
Ofan
Out with the old. Rebuild into a new case.
Replies
0
Views
2K
Ofan
Ofan
C
Air bubbles
Replies
5
Views
2K
Cipher .
C
Back
Top