Derlin Vandal switch

mastering3d

New member
Hi there i did look at another post on this forum but seeing as it was old ,I would ask in another topic on this .

Ok i have the led working np on the switch and have that set as power light and hard drive active light .

But then i get stuck with the powering up and down ,

I set the wires to the mombo for power on and off but as soon as the pc boots it just powers down again ,with out touching the button .

Any ideas guys .
 
have you wired it up the the right pins on the switch? Have you tried another switch?

pretty sure you need pins 3+4 for push to make.

Sounds to me like you have wired it as push to break
 
Back
Top