Corsair 350D - PlastiDip?

[TheUnkn0wn]

So I've got my mind set on a 350D build, but unfortunately the 350D only comes in black. So after doing some research I've decided that PlastiDip would be a very good solution to that problem since if I don't like it I can just peel it off and I don't need to sand, prime or use different paints . I've made a quick (and I mean quick) mock up of what I'm thinking of using photoshop.

What do you think?

Has anyone tried PlastiDip before and had any problems?

 

[Kopesetic]

Personally, I would leave the front plate and bay covers as they are. Do the rest, except the inside, in white.

 

[TheUnkn0wn]

The beauty of PlastiDip is, I can spray the front anyway and see how I feel about it. If I don't like it I can just peel it off

I also don't plan on spraying the inside, just both the sides, top and front.

As for the Corsair logo being covered, I can buy a metal corsair logo off eBay to go over the top.

I also plan on buying some white fans (Corsair Air Series?), does anyone have any good suggestions for white silent fans?

 

[Tripp]

Plastidip aint all that hardwearing mate trust me

 

[TheUnkn0wn]

I thought that, but I'm not going to be moving the case about so there's less chance of scratching it and I can do quite a few coats. If I do scratch it I can just spray over it?

 

[Tripp]

yeah make sure you do a few coats but dont put anything on it an don't move it much or rub it with anything damp

 

[TheUnkn0wn]

Have you used PlastiDip before?
Can I clean my case if I PlastiDIp it?

 

[Tripp]

yeah i painted my desk black with it to match my furnishings in my living room, dont get me wrong its good stuff but it does scratch easily. you can clean it just be quite careful fella, i have to spray my desk again as my wrist has taken some of the coating off (from just where its lent when using the mouse)