Bench table design... ideas/thoughts welcome.

[Azza]

How does this look people as an initial design?

This is the top, still got to do the lower area for hard drives, PSU, watercooling rad etc...

Phase evap will come in some where from the left going over the 120mm fan im guessing...

The lower area maybe...

Just not sure about where the res for watercooling would go.

Obvisouly non of these drawings are to scale.

 

[Thickbrit]

Looks like a reasonable plan.Maybe you could consider some cooling for the h/d's.I think the lower fan would be better placed on the left side of pic to pull air over top and bottom of gfx card/s.

 

[Azza]

Looks like a reasonable plan.Maybe you could consider some cooling for the h/d's.I think the lower fan would be better placed on the left side of pic to pull air over top and bottom of gfx card/s.

Yeah.

Been thinking about a fan in front of hard drive cage and a fan at the end of the gfx cards to pull the air away from them.

 

[stocky]

Try to create air tunnels with the fans, as that way the hot air will be sucked away and be replaced with cooler air.

 

[Johnny Bravo]

remember that the mounting holes for cpu fans/whatever are different between boards so if you're drilling in posts to mount the motherboard don't drill 4 for the cpu socket area. leave that area open so that you can just use a back plate on the board itself.