killeroverload
New member
Ok,
Well i've been looking around for a not too large beer cooler and i've seen this one http://www.scot-bev.com/products/beercalypso.html its the Calypso 9one with two lines and a recirculation pump (probably won't be used but hey). But it says it's got a 11cc compressor (don't know which brand) which i think translates to about 1/3hp, most of the other units that i have been looking at that are an acceptable size are about 1/5hp.
Any ways my question is what sort of temps do you recon i should be getting the water to under load (s754 3700+ @2.8ghz and 1.7v and a x800xtpe) leaving the unit unmodded with the exception of moving the thermal probe on the unit to somewhere nice and hot (I want to build a custom case and use the unit 24/7 so don't want the unit to be too big and as i'm a student cost is also a factor for me).
any help or advice would be greatly appreciated
Well i've been looking around for a not too large beer cooler and i've seen this one http://www.scot-bev.com/products/beercalypso.html its the Calypso 9one with two lines and a recirculation pump (probably won't be used but hey). But it says it's got a 11cc compressor (don't know which brand) which i think translates to about 1/3hp, most of the other units that i have been looking at that are an acceptable size are about 1/5hp.
Any ways my question is what sort of temps do you recon i should be getting the water to under load (s754 3700+ @2.8ghz and 1.7v and a x800xtpe) leaving the unit unmodded with the exception of moving the thermal probe on the unit to somewhere nice and hot (I want to build a custom case and use the unit 24/7 so don't want the unit to be too big and as i'm a student cost is also a factor for me).
any help or advice would be greatly appreciated
