Winxp 64 raid drivers for DFI NF4 SLI-DR

[ZaX]

Lo,

Been trying to install WinXP 64 on a partition on my raided drive. I'm using the Sil 3114 controller. I've tried the winxp64 raid drivers from the DFI website but after doing the F6 routine during install the floppy isnt recognised. I've tried Silicon Images site and Planet amd64 to no avail, all the drivers I've tried don't seem to work. I've tried different floppies too. Any ideas guys?

Cheers.

 

[maverik-sg1]

Hi Zax mate,

Can you use the NVRAID instead? Should be okay..... I think?

Mav

 

[ZaX]

I would prefer not to as I want to dual boot my system with winxp 32 and thats already on the first partition of my raid. If I used the NVraid I would loose that and I'd have to start again from scratch.

Cheers.

 

[boardy]

I got this to work with the Sil 3114 controller on another mobo, can't for the life of me remember where I got the drivers from tho

I'll have a look at some point in the next few days see if I can find the disk, and if I can I'll whack an image of it on my website for ya mate.

 

[ZaX]

Cheers Boardy, I've been trawling the web for a driver, trying to get this to work. I've tried countless drivers, as of yet nothing , can't get my raid 0 recognised during setup.

 

[maverik-sg1]

Is it possible that one of the raptors have bit the dust?

 

[ZaX]

Nah Mav, it all works with 32 bit drivers.

 

[Gaffney982]

Zax, lemme know when you find these drivers because I'm encountering the same problems. Also, is there a way to load the drivers when setting up winblows with a usb flashdrive instead of using the dang floppy drive?