OC3D Review: Cooler Master Cosmos S Case

[JN]

"We take a look at Cooler Master's all-aluminium (well nearly) Cosmos S case"

Cooler Master Cosmos S Case

 

[ionicle]

now that looks like a nice case...

especially for watercoolers

i'm guessing if you wanted to, if not watercooling, you could have 3 120 mil fans just on the top of the case, blowing hot air out, which would work like convection

 

[Mr. Smith]

It's ok; too much plastic (any plastic on a case is too much) and doesnt accept thermochill rads :/

 

[JN]

It's ok; too much plastic (any plastic on a case is too much) and doesnt accept thermochill rads :/

Yeah problem with thermochill rads is if you design a case to take one, it wont take anything else...and the global distribution of thermochill pretty much sucks

 

[Luigi]

Just a little heads up, the last page on the page selector is called "double click to edit"..

I havent had a chance to read through it all, this may be explained but whats the 24pin for?

 

[FarFarAway]

Oops so it is, changed

Case looks nice, fantastic to be a 360mm RAD ready

 

[equk]

I think it looks good for cooling and nice to be ready for watercooling etc.

It's a shame it looks really plasticy and cheap (even if it isn't)

Looks like Alienware meet Lian-Li

 

[XenoMorpH-TDI]

Looking at the back of the CosmosS. The casefan is much larger than standard casefan. I don't think CoolIT WC setups won't be able to fit on it?

 

[da2ca]

I really like it. If i was looking for a new case it would make the short list, no probs.

 

[!TIMMY!]

Very good review, looks a great case of internal water cooling. Timmy loves Coolermaster cases

 

[hadesan]

I love this case - lots of room for everything. One problem is the right side of the case and cable management. It gets somewhat tight with the support bars that are in place. Looking to water cool and will see how it goes for that.