Minor Update

[daniSAUR]

Hey guys,

I've just purchased a new case (CM690 II Adv. thanks to MSm2 ) and PA120.2 and I wanted to do a minor update on the barbs and hoses.

Currently I have Feser white 3/8" ID - 1/2" OD pipes and i wanted to see recommendation from you all. Current setup is:

CPU block: Swiftech Apogee

GPU block: EK-FC88

Pump: Laing DDC Ultra Pump with EK Derlin Top

Rads: 1x XSPC RS120, 1x XSPC RS240 (going to replace RS120 with PA120.2 )

Tubing: Feser white 3/8" ID 1/2" OD

Fans: 2x Slim Yate Loon, 1x Yate Loon (all 120mm)

So for the time being it's barbs and tubing I'm really aiming for. Little face-lift if anything.

Thanks in advance!

Dani

 

[Msm2]

Cheers daniSAUR put some pics up...

 

[daniSAUR]

Will do Msm2

Case should be here Monday, along with the PA120.2.

I've had a few compression fittings before but was never 100% certain on... well, sounds stupid but I wasn't really aware on how to install them So I may get some of them as I've seen how they're done up.

Recommendations away peeps!