Gangster's Intel WC'd

[Gangster]

Hey all,

Just finished this yesterday, thought i'd get some night pics up... (+ day pics now )



Did some tidy ups, mainly got that ide cable behind the tray and tidy'd up a few molex's here and there

Let me know what you think .

 

[stocky]

Looks vibrant

I probably would have located the UV tubes out of view so that they are not so dazzling, but perhaps how it looks is a bit different...

Daylight pics please

 

[Gangster]

Daylight pics added.

As you can see few minor changes, one being the ccfl's put together rather than across the window.

 

[unreal]

You should invest in an alphacool DDC top for the pump, improves performance loads and you can insert LEDs into it as bling is clearly your thing. Also it supports 1/2" barbs so you will actually not be at risk from leaks (as you currently are).

Also: your loop design is a little poor you are creating a little kink where you move from rad to cpu block.

You would be better going from pump to the far rad barb (basically just switch which in and out you use on rad) or possibly swaping the cpu block around to give you some more room to move the tubing.

Edit: Ah sh1t, I think you might have loop order mucked up, is your cpu block the same on both sides? From this angle it look looks like it should have a specific in and out which you have wrong, even if theyre not you should swap them to try and remove that kink!

 

[Gangster]

You should invest in an alphacool DDC top for the pump, improves performance loads and you can insert LEDs into it as bling is clearly your thing. Also it supports 1/2" barbs so you will actually not be at risk from leaks (as you currently are).

Also: your loop design is a little poor you are creating a little kink where you move from rad to cpu block.

You would be better going from pump to the far rad barb (basically just switch which in and out you use on rad) or possibly swaping the cpu block around to give you some more room to move the tubing.

Edit: Ah sh1t, I think you might have loop order mucked up, is your cpu block the same on both sides? From this angle it look looks like it should have a specific in and out which you have wrong, even if theyre not you should swap them to try and remove that kink!

At the moment the loop is:

Res>Pump>Rad>Cpu

I am however in the process of buying - Fillport, Brass T (1/2'') and soon to get the acrylic top because as you've said im currently risking a leak there.

Thanks for the advice, next drain i'll switch the way the rad is configd so the 'forming kink' is avoided.

Also the CPU block has its "Inlet - Left Side" and "Outlet - Right Side".

thanks for the help.

 

[Master_G]

Looks good, get the DDC top and you should be sorted.

G

 

[sacha35]

looking nice M8, just spend a bit of time tidying cables and lights up and it will look very sweet.

 

[phil123]

looks good but would be a lot better with a danger den nv78 tbh *Subtle hint*

 

[Gangster]

Thought I'd update my rig pics...

Switched over to a Pc7 plus because i felt like it

Day Shot:

Night Shot:

 

[OV3RCLOCK3R]

Very nice joe. I'd suggest adding more die to the water to make the colour more vibrant/darker and also, push that baby upto 3.5/3.6ghz