Define R5 Front I/O trouble

[Rak]

Hello there!

I'm in a little pickle. I'm trying to connect the front I/O of my Define R5 with my Asus M8 Ranger Z170, but cannt figure out where/how to plug the connectors in.

I consulted the motherboard manual and did take a look in to the case manual but asus seems to use a different soultion than pictured by fractal.

Not to speak of the reset cable used by fractal where booth ground and reset are black...

If someone could assist my with a fool proof guide i would be very thankful!


I'm in a little pickle. I'm trying to connect the front I/O of my Define R5 with my Asus M8 Ranger Z170, but cannot figure out where/how to plug the connectors in.


I consulted the motherboard manual and did take a look in to the case manual but asus seems to use a different solution than pictured by fractal.



Not to speak of the reset cable used by fractal where booth ground and reset are black...



If someone could assist my with a fool proof guide i would be very thankful!

 

[Mysterae]

There is no polarity for the reset switch so you can connect in any of the two combinations.

Check your manual again for the I/O pinout; they are both modern hardware so will follow the standards and specifications.