BigDaddyKong
Active member
Aquaero 6 Pro 3 Pin Fan Control
If I connect a 3 pin fan to one of the 4 pin headers, should it run at full speed until I select voltage control?
I have tried 4 different brands of 3 pin fans on my Aquaero 6 Pro and it will not spin them up. I have even set it for voltage control and 100% minimum speed along with a 100% start boost and can not get it spin up the fan.
I have 6 Corsair fans on splitter blocks, and moved the headers they were connected too and they still ran just fine. Those blocks are powered, so that may be the difference.
Any ideas?
If I connect a 3 pin fan to one of the 4 pin headers, should it run at full speed until I select voltage control?
I have tried 4 different brands of 3 pin fans on my Aquaero 6 Pro and it will not spin them up. I have even set it for voltage control and 100% minimum speed along with a 100% start boost and can not get it spin up the fan.
I have 6 Corsair fans on splitter blocks, and moved the headers they were connected too and they still ran just fine. Those blocks are powered, so that may be the difference.
Any ideas?
Last edited:
