XSPC GPU block

[younus1932]

Hello all,

i recently made a new rig with the help of you guys. thanks alot. but i am in a problem which does not seem to resolve . i've been trying to bleed air bubbles from past 2 days but still didnt get rid of them and then today i realized there was a screw missing from my xspc gpu block. check the screen shot. could that be the cause of air entering the loop ? .. please help guys thanks

 

[jamesriley94]

Nope - that couldn't cause any air at all.

Most of he screws on the XSPC blocks go into the acrylic panel which is actually a completely different part to the block itself! Even if it did go into the block itself, it wouldn't be letting air in.

Try increasing the pump speed to maximum and running it for a couple of days. Also, putting the PC upside-down/on its side etc will help. If they're tiny bubbles, the block will still work fine, so you'd get away with running it properly, but after a few weeks they should go.

 

[tinytomlogan]

Something to note is you have your memory set up wrong too the ram should go in the same colour slots not right next door to each other