J justin New member Oct 8, 2005 #1 hey, just connected up screen on prommy to find that is remains blank, any ideas? (the unit still powers up, just no screen action) Justin
hey, just connected up screen on prommy to find that is remains blank, any ideas? (the unit still powers up, just no screen action) Justin
M maverik-sg1 New member Oct 8, 2005 #2 Reflash the firmware - oh and make sure the screen is connected up properly (just in case). Cheers Mav
Reflash the firmware - oh and make sure the screen is connected up properly (just in case). Cheers Mav
F fatty New member Oct 8, 2005 #3 If you have connected the lcd up wrong it can do damage to the control board be very careful mate
J justin New member Oct 8, 2005 #4 yeh, i checked a few times before i turned it on...thats quite the annoying, as it didnt come with any instructions and it was kinda quess work..how much for a new controller
yeh, i checked a few times before i turned it on...thats quite the annoying, as it didnt come with any instructions and it was kinda quess work..how much for a new controller
G GoLLuM4444 New member Oct 8, 2005 #5 I plugged a blue one in using a cable from a green one and it broke the display but not the board. Dunno if that's relevant.
I plugged a blue one in using a cable from a green one and it broke the display but not the board. Dunno if that's relevant.
J justin New member Oct 8, 2005 #6 ok, the controller aint broken (i think) i unplugged the screen and everything goes back to normal, i think its a faulty screen...
ok, the controller aint broken (i think) i unplugged the screen and everything goes back to normal, i think its a faulty screen...
F fatty New member Oct 8, 2005 #7 I have had a blue one with a bad screen connection could also be dirty pins ??
J justin New member Oct 8, 2005 #8 mm maybeee, i dont think so though, i reckon its just a busted screen, very strange...
