New Mach2 user

[Norbert666]

Hi,

I've just ordered myself a Mach2.

I'm going to be using it on my XP2500m and a DFI Lanparty B board.

I'm a phase change noob, so be gentle.

Are there any issues with this board I need to be aware of? I ask this as I had to trim down the washers when fitting my watercooling on this board. Will I have similar issues?

Also, any other friendly advice you might want to add would be much appreciated.

Thanks and regards

James

 

[Phil Stanbridge]

Hi,

I've just ordered myself a Mach2.

I'm going to be using it on my XP2500m and a DFI Lanparty B board.

I'm a phase change noob, so be gentle.

Are there any issues with this board I need to be aware of? I ask this as I had to trim down the washers when fitting my watercooling on this board. Will I have similar issues?

Also, any other friendly advice you might want to add would be much appreciated.

Thanks and regards

James

I've used this board mate with my Mach II, no major issues, but the temp probe is wrong, so dont take the temps seriously.