Dawelio
Active member
Hey guys,
Not sure if this is the correct place to post in, but if it's the wrong section, please move it to the correct one.
I was wondering if anyone know any way (other than molding) to change this light to a blue one. If there's like a plastic or rubber cover you can slide over the light itself to change the light. As spray painting it would quite a pain to be honest... plus, I don't think that Plastidip is that resistance to heat, which this light most likely will output a little bit.
But as I said, if anyone knows any way, please share!
Thanks!,
Chrazey
Not sure if this is the correct place to post in, but if it's the wrong section, please move it to the correct one.
I was wondering if anyone know any way (other than molding) to change this light to a blue one. If there's like a plastic or rubber cover you can slide over the light itself to change the light. As spray painting it would quite a pain to be honest... plus, I don't think that Plastidip is that resistance to heat, which this light most likely will output a little bit.
But as I said, if anyone knows any way, please share!

Thanks!,
Chrazey