maniac
New member
So, basically title says it all. I just bought sleeving, heatshrink and the tools to remove the pins, I managed to sleeve a couple of molex and remove the female ATX pins but the male ones seem impossible for me to remove.
Before suggesting, yes I did watch a ton of videos and read the other thread on OC3D about removing them but still no luck, I've tried with the proper tool and with a grinded down paperclip, but still after pushing it down all the way as far as it will go (even tried forcing it further), the pin won't seem to budge, I pulled it so hard I started to hurt my fingers.
Any help will be highly appreciated.
Regards,
Maniac
Before suggesting, yes I did watch a ton of videos and read the other thread on OC3D about removing them but still no luck, I've tried with the proper tool and with a grinded down paperclip, but still after pushing it down all the way as far as it will go (even tried forcing it further), the pin won't seem to budge, I pulled it so hard I started to hurt my fingers.
Any help will be highly appreciated.
Regards,
Maniac
