Enermax Magma fan Q & A

[Chaney579]

I would like to use these fans on my next build, Due to easy cleaning LOW noise with big air movement. And the colors are good, the only problem with them are that they are a good penny per fan, Is there a place where i can buy in bulk for cheaper? Or what. I need 9 or so of the bad boys D:

 

[Chaney579]

Bump

 

[heartspains88]

these are what I was looking at also. so I'm curious as well.

 

[Icekube]

I'm running 2 of these on my H70 atm. They're decent enough, but they are by no mean quiet, I'm using Noctua resistors to tune them down a bit, otherwise they'd be almost as loud as the cr@ppy stock Corsair ones. But on the plus side they shift a ton of air.

Honestly if i had the choice again I'd have gone with the Coolermaster sickle flow, I'm just waiting to see how the new H100 fairs in reviews, if it's good I'll be switching to it and buying 2 x 120 red sickleflow's

 

[Chaney579]

I'm running 2 of these on my H70 atm. They're decent enough, but they are by no mean quiet, I'm using Noctua resistors to tune them down a bit, otherwise they'd be almost as loud as the cr@ppy stock Corsair ones. But on the plus side they shift a ton of air.

Honestly if i had the choice again I'd have gone with the Coolermaster sickle flow, I'm just waiting to see how the new H100 fairs in reviews, if it's good I'll be switching to it and buying 2 x 120 red sickleflow's

Hmm you dont say, Well >.>, i would be running 5 of these. BUT i am 17 and i would have a headset or my surround up, and along with that im a texan from america. A little noise just means its worken

. As long as they arnt defining then im fine.

. Honestly im just a little OCD about dust on my hundreds of dollars of components. The ability to take the actually blades off allows you to be able to get a rag around the trim of the fan and then just run the blades under water