Custom PSU Cables

Boonstick

New member
Hi all,

I need to make some fully custom PSU cables for my Corsair AX860i PSU. I'm not intending on braiding them as the way my case is laid out (custom made case) you actually won't see any cables but the ones that came with the PSU are way too long and I need to shorten them. What is the molex pin type that I will need to remake the ends off? It will be the end that goes into the PSU itself.
Also can anyone recommend a decent shop/website where I can buy them from, preferably in the UK?

Thanks in advanced. I'll hopefully upload some pics of the system once it's al finished :)
 
If you are not going to see any of the cables I would be inclined to cut the psu wires to the length you want then rejoin them by soldering and just use heatshrink to seal them as they don't need to be aesthetically pleasing to the eye and it would be a cheaper option for you Bud :) just take your time by doing 1 wire at a time if not try here for your connectors I hope this helps you finish your build http://www.aquatuning.co.uk/cables/connectors/
 
Last edited:
Tolemac, did not know Aquatuning did those parts, guess they'd come in handy if I were to go down the custom cable route on my Seasonic 660w.

Ta.
 
tbh look at RS online as well they may do them cheaper also some of the pc watercooling suppliers in the uk stock them buddy :)
 
Back
Top