2 Radiators, 2 Pumps, 1 Loop?

[Nick R]

I intend on using two PA120.3's in the same loop, can I/should I use two pumps?

 

[Luigi]

nope, you dont need to, but it would be better

 

[Nick R]

Ok, so I'm thinking this:

with a QX9775 to as fast as I can get it.

 

[Luigi]

QX9770 i hope, the 775 is for skulltrail

Thats a lot or rad, A single pump should be fine through that, similar to what im doing, but im using quads

Seen as its only a single block, 1 pump is fine

Have you looked at phase?

 

[Nick R]

So it is, my mistake, couldn't remember which was 775 and which was 771 xD. I've glanced over it but it would prefer to start at a slightly lower step.

 

[Luigi]

Ok, Sounds good then single pump will be fine... I was going to call all that radding ott then remembered my builds gna have 2 quads

 

[Nick R]

Ok then, the only real reason for two rads was to add some expandability such as graphics card, memory etc.

 

[Aqua-Pc's]

SIngle pump would be fine on there

 

[EazzyTarget]

Just wondering what is it you are gaining by hooking the pumps in serial?

To increase flow rate through the loop they would have to be in parallel... no? Otherwise, there is no appreciated gain... is there?

-EazzyTarget