Go Back   OC3D Forums > [OC3D] General Forums > OC3D News
Thread Tools Display Modes
Old 31-07-17, 09:38 PM
WYP's Avatar
WYP WYP is offline
News Guru
Join Date: Dec 2010
Location: Northern Ireland, United Kingdom
Posts: 10,069
Asetek confirms that a TR4 retention kits will be included with all AMD Threadripper

This means that lots of existing coolers will support Threadripper out of the box.

Read more on Threadripper's bundled Asetek retention bracket.

I'm not saying that 1984 is a bad book, but the dystopia we are currently living in has much better worldbuilding.
Reply With Quote
Old 31-07-17, 11:27 PM
NeverBackDown NeverBackDown is offline
AMD Enthusiast
Join Date: Dec 2012
Location: Valhalla
Posts: 12,982
Very good for AMD, they seem to be trying very hard to make sure the launch is as smooth as possible. Which is good since Ryzen's launch was a bit shaky despite it's impressive performance.

I think the coolers should do fine. AMD made a smart move to make sure that the actual working dies on TR are diagonal to spread the heat output over a greater surface area which should help them from heating each other up. We will see how it works out
“For even the very wise cannot see all ends.”
― J.R.R. Tolkien, The Fellowship of the Ring
Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT. The time now is 03:43 AM.
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.