Go Back   OC3D Forums > [OC3D] Cooling Forum > Liquid Cooling
Thread Tools Display Modes
Old 15-04-12, 11:56 AM
grandpatzer grandpatzer is offline
Join Date: Jan 2012
Posts: 249

I'm about to install the oem Laing ddc-1t pump, but according the wiring there is a gap on pump between + and -, will it 100% works without rewiring?

If it's black to - and red to + then connecting that 3 pin adapter will not give both + and - because there is a gap between them?

so I would have to move the middle wire to left to have pump turned on from psu?

edit--> It's the 5th picture on this site http://martinsliquidlab.org/2011/03/...-ddc-1-ddc-1t/

so there is a gap between + and -

i5 [email protected]_Pure P67_3x 7950 1100/1575_XMS3 2x4GB 1600mhz_F120 Corsair + C300 64gb_Water Dual D5, Phobya 1080, 19/13 Tubing, T-Line Win 7 64bit 1000w Golden Green_Fractal R2_Razer Abyssus
Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT. The time now is 05:04 PM.
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.