Go Back   OC3D Forums > [OC3D] Cooling Forum > Liquid Cooling
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 23-07-18, 07:48 AM
tolagarf's Avatar
tolagarf tolagarf is offline
OC3D Crew
Join Date: Jun 2013
Location: Denmark
Posts: 849
Controlling Fan Speed Using Temp Sensor with BIOS

So I have a temperature sensor attached to my water loop and I wanted to adjust my fan speed depending on the water temperature through the BIOS, but I can't seem to get the fans to react to it, at all.

Motherboard is an ASUS Z270 TUF Mark.1, and the temp sensor reports lowest temps at 37C and highest at 45C. So I set up a curve in the BIOS selecting the source as Temp Sensor 1 where it's located, I can see the BIOS reporting a temperature, but there is absolutely no reaction from the fans at all. I used HWInfo to check the temperatures going up while stress testing the system, so it's not like the temp sensor isn't working.

I used the following PWM curve in the BIOS

PWM connector: Chassis Fan 2
Source: Temp Sensor 1
Max: 50C / 60% duty cycle
Middle: 45C / 50% duty cycle
Min: 38C / 25% duty cycle

So what's going on here? Is the BIOS just failing to control the PWM curve when Temp Sensor is selected as source? I'm starting to wonder if this is the case, or something else is happening I haven't thought of.
Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT. The time now is 05:48 PM.
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.