Go Back   OC3D Forums > [OC3D] Processors & Platforms > Memory
Thread Tools Display Modes
Old 15-08-19, 10:57 AM
mutantaxe mutantaxe is offline
Join Date: Aug 2017
Posts: 105
Problems inserting memory

Swapping memory between PC's and both machines wont boot...get errors . Inserting memory among cables and water hoses and they seem to go in but and not correctly it seems.

Ended up putting one PC on its side and putting the memory in again and found out by putting them in this manner and inserting them carefully and pushing down evenly and then putting down on the non lever end you hear a very small click and then push down on the other end for the lever to click in a bit more loudly worked.

And have ended up leaving the Corsair Cube case on its side as the 1080ti had some very bad sag and with 3 fans at the front and 2 140's at the bottom the airflow is better ...well the temps a down a fraction Core Temp shows all my cores from 24 to 26C at the moment ( usually about 28-30C ) but its is a cool night....cant afford heating but thankfully 8C is the lowest it gets overnight down here

So anyone eles having problems inserting ram....

Reply With Quote
Old 15-08-19, 10:39 PM
Davva2004's Avatar
Davva2004 Davva2004 is offline
OC3D Elite
Join Date: Dec 2013
Location: Nottingham UK
Posts: 1,161
No mate, even pressure across the DIMM and making sure the latch clicks means they are seated. Never had a problem.
Reply With Quote
Old 16-08-19, 02:34 AM
mutantaxe mutantaxe is offline
Join Date: Aug 2017
Posts: 105
never had problems before but I usually put the ram in before I put the mobo in the computer
Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT. The time now is 11:40 AM.
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2021, vBulletin Solutions, Inc.