Go Back   OC3D Forums > [OC3D] Hardware & Software > Storage Mediums
Thread Tools Display Modes
Old 22-04-17, 03:01 PM
Vipermk2's Avatar
Vipermk2 Vipermk2 is offline
Join Date: Apr 2017
Location: UK, Sol 3
Posts: 98
Arrow 960 Pro Problems

I have a Rampage V edition 10 with 2 M.2 drives connected.

1 x 960 Pro attached to the M.2 slot on the mobo partitioned into 2, one for system and one for games.

1 x 950 Pro attached to the PCie 8_4 slot via an adapter which there seems to be no problem with at all. See image below.

When it comes to the 960 Pro its a different matter, the reading seem to be all over the place especially the system drive which drops as low as 1875 on sequencial read (which i didnt capture) but the Samsung magician gives very much different results even when Crystal Disk Mark shows relatively high readings but not as high as the 2nd partition.

System Drive:

The D drive is what it should be:

The only reason I noticed was because I tested my rig at User Benchmark after ugrading quite a few components and noticed the 960 Pro was performing badly

Any ideas why this is, the NVMe driver is up to date and so is the drive firmware.

ROG Maximus XI Code - i9 9900k - 32Gb Corsair Dominator Platinum - Samsung 960 Pro 512 - Seasonic Prime 750w - Noctua NH-U14S - K70 RGB LUX - GTX 1080Ti Strix - Acer Predator XB321HK- Windows 10 Pro x64
Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT. The time now is 01:39 PM.
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.