Go Back   OC3D Forums
View Single Post
  #41  
Old 21-04-15, 12:54 PM
cooperman's Avatar
cooperman cooperman is offline
OC3D Crew
 
Join Date: Nov 2013
Location: UK/west-mids
Posts: 763
Quote:
Originally Posted by FredEx View Post
I see diagonal cutters, but a good pair of flush cutters is a must have. Trim anything you'd cut with diagonals, but flush cutters as named, cut flush. For example, cut a tie wrap and a flush cutter trims it so no sharp edge sticks out. I've used them for decades in component level circuit board repair to trim off excess leads. Note in the pic that the side with the cutting edge is flat and cuts things off flat.

I have allways used one of those too but i use them just for cuting cable ties
__________________
i5 4690-Gigabyte Z97P-D3-16Gbs 1866Mhz Kinston HyperX Fury Black-Asus GTX 980 Corsair h80i-sandisk 256gb ultra plus-250gb Intel SSD-WD Blue 500gb-Seasonic M12-620w-Cooler master haf xb.
Reply With Quote
 









All times are GMT. The time now is 11:23 AM.
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.