Go Back   OC3D Forums
View Single Post
  #8  
Old 30-11-07, 11:32 AM
SuB's Avatar
SuB SuB is offline
The Webmaster
 
Join Date: Jul 2005
Location: Taking a break
Posts: 8,717
for your ram if its spd'd at 1066

go into uguru in the bios and set the thing to manual, set your ram to voltage it says it should be at which is 2.1v

then look for the ram divider function change that till the reading on the right says 1066(or as near to it as you can i think mine comes up as 1088 but thats not much more) i believe its 1:2...

my ram's stock voltage should be 2.2v it's not overclocked yet so setting it up from the default 1.8 made it work at it's stock speed

if you let it set its timings by spd it should be fine as long as you're putting the right voltage (2.1v in your case) through the ram

if you open cpu-z and go to latency tab it'l tell you what the ram can do at different settings just go by that
__________________
Gigabyte Z390 Aorus Pro | i7-8700k | 32GB Corsair Vengeance 3000Mhz DDR4 | nVidia RTX 2080Ti | Creative Audigy Rx | 1Tb Samsung 970 EVO+ M.2 | 1TB Samsung 860 QVO | 2TB Seagate Barracuda | Corsair RM850 | Fractal Define S | Noctua NH-U14S | Roccat Kone Optical - Navy Storm | QPad MK85 Pro w/ Cherry Red MX | DELL U2413 + 2 x U2412M | AKG K702's | AKG K7XX S/N#000016 | Beyerdynamic DT770 Pro 250Ohm | TM Hotas Warthog Stick and Throttle | Saitek Combat Pro Pedals | TrackIR 5 | TrackClip Pro

Notice: Don't feed the trolls!
Reply With Quote
 









All times are GMT. The time now is 08:40 PM.
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.