Go Back   OC3D Forums
View Single Post
Old 04-03-15, 12:27 PM
Unframed Unframed is offline
Join Date: Jan 2013
Posts: 13
Yes the voltage is set to auto, but is between 1.025-1.035 during the Cinebench, according to CPU-Z.

Not really anything around the socket that should curse a problem for it to sit correctly on top of the CPU.

The rads I'm using is from my last build and I did do a good flushing before using them then and as well now before using them in my new build.
It's a bit hard to look inside the block since I got the Original CSQ model with a frosted look to it. But from what I can see it doesn't look clogged. But shouldn't this also effect the GPU temps if there was bad flow through the system?
Reply With Quote

All times are GMT. The time now is 07:00 AM.
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.