Go Back   OC3D Forums > Search Forums
Showing results 1 to 8 of 8
Search took 0.00 seconds.
Search: Posts Made By: AlienALX








Forum: Liquid Cooling 05-06-20, 06:30 PM
Replies: 34
Views: 2,510
Posted By AlienALX
Some pastes have to be spread. They are too thick...

Some pastes have to be spread. They are too thick to spread properly when you screw down the cooler. Case in point, Arctic Ceramique which I used for many years.

It depends on the paste and the...
Forum: Liquid Cooling 04-06-20, 11:19 AM
Replies: 34
Views: 2,510
Posted By AlienALX
I've not had the same results. That said paying...

I've not had the same results. That said paying four times as much for something that apparently and clearly makes such a tiny difference is nuts.

It's decent for direct to die on GPUs as it's not...
Forum: Liquid Cooling 04-06-20, 09:46 AM
Replies: 34
Views: 2,510
Posted By AlienALX
Because he is not the lord of science and...

Because he is not the lord of science and physics. He spreads and uses his TIM in the way that he does because he is into extreme cooling.

As it goes Kryonaut is not the best TIM out there. It's...
Forum: Liquid Cooling 26-05-20, 11:05 AM
Replies: 34
Views: 2,510
Posted By AlienALX
Or the inlet outlet wasn't right.

Or the inlet outlet wasn't right.
Forum: Liquid Cooling 25-05-20, 12:18 PM
Replies: 34
Views: 2,510
Posted By AlienALX
It wasn't the tightness of the threads for me. It...

It wasn't the tightness of the threads for me. It was the block's holes. The screws have a non threaded part and it literally had to be shoved into the holes.

You have two options. 1, get a small...
Forum: Liquid Cooling 24-05-20, 11:39 PM
Replies: 34
Views: 2,510
Posted By AlienALX
That's not right at all. I might know why too. ...

That's not right at all. I might know why too.

OK first up let me just say that my 3950x idles in the 30s to low 40s tops on a dual 120 AIO. It's not even an expensive AIO. It's Corsair's...
Forum: Liquid Cooling 24-05-20, 02:04 PM
Replies: 34
Views: 2,510
Posted By AlienALX
Hmm it's a big block (should fit TR4 too) so I...

Hmm it's a big block (should fit TR4 too) so I can't see it being off centre with the CPU and even if it were it should be fine. Dumb question but you did remove the protective vinyl off it right?
...
Forum: Liquid Cooling 24-05-20, 01:15 PM
Replies: 34
Views: 2,510
Posted By AlienALX
Pic of it would help. Have you enabled PBO? what...

Pic of it would help. Have you enabled PBO? what is your LLC setting?
Showing results 1 to 8 of 8







 
Forum Jump

All times are GMT. The time now is 02:55 AM.
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.