Recent content by reeper250

[Project] Dovah I would have started this build log earlier but I became occupied by this build, hence the large slab of images... This setup is temporary while I complete work on my Lian Li V2010 (Copperhead) Specifications: ASUS Rampage IV Extreme Zotac GTX680 4GB i7 3930k G.Skill Ripjaws...

I am looking at buying a second GTX680 4GB or second 7970 for a multi GPU setup for my build. I am currently using a single 2560x1440 monitor but may add more (possibly two 24"s down the track). I have both the 680 and 7970 and would rather keep them then buy a GTX 770 or 780 because in...

[Project] Copperhead I've had this case for a while now and finally decided to use it. This build will have copper pipe running through it instead of the 'standard' tubing. I have also got parts for a remote controller RGB lighting system. Hardware i7 3930k ASUS Rampage IV Extreme 16GB...

I was wondering if it is possible to run a GTX590 with a GTX580 in tri-sli with a modified BOIS of some sort? Thanks

Got this Silverstone RV02-E very cheap second-hand so I decided to mod it. Not sure what hardware is going into this. Might use it as a case for a client build.

Nuclear Poison I would ordinarily take progress pictures but the case mods have been done very gradually over a long time and some even before my last build done in this case (Nuclear Fission). Also I kind of got stuck into this build last night and ended up going to bed at 2:40 in the morning...

Just like to share with the OC3D community; built myself a custom carbon fiber road bike with Campagnolo components. The entire bike cost me approximately $1500 which is very good considering all the components were new except my seat and tyres! Athena 11 Speed Rear Mech Athena 11 Speed Front...

i7 950 @ 4GHz Rampage II Extreme 6GB OCZ Reaper Coolermaster Silent Pro M2 720W HIS 7970 IceQ X² Turbo 3GB Xigmatek XLF F1254 White LED Fans 30cm White LED Strip G-VANS Legion Xigmatek Thor's Hammer Black Paracord 550 Sleeving Creative Supreme FX-Fi

I believe a lot of people, including myself, want to know what clear tubing stays clear the longest, has the best bend radius, most transparent, etc? Tubing I have heard of: Tygon Duralene Masterkleer Primochill

I am wondering if there is any block that is compatible with the south-bridge on my AsRock X79 Extreme9. The 'XFan' that cools the south-bridge on the boards get extremely loud at load and when it gets hot. I have already tried turning down the fan, even having it set to off until the chip...

Looking for a new pair of headphones which will primarily be used for music and possibly a tiny bit of gaming. I listen to Rock, Metal, Heavy Metal, Bass Music (Drum n' Bass, Glitch Hop, etc), Classical, Jazz, and a bit of Rap. Looking at spending anywhere up to around the $125 AUD mark...

Hey guys and gals, I just drew up a new Avatar to use in the forums. I call it "DropJaw Skull" What do you think? All versions here: http://imageshack.us/g/1/9841751/

Emerald Shark i5 2500 @ 4GHz AsRock Z68 Extreme3 G.Skill Ares @ 1600MHz CL9 Silverstone Strider 700W Sharkoon T28 Case WD Caviar Blue Zotac GTX570 Here is the case in it's 'normal' state without hardware: Then here is the build/modifications:

When I tried updating my Incredible S to JellyBean from an ICS ROM, I forgot to S-OFF my phone. For some reason it reverted to S-ON when I did a Factory Reset so when I attemped the ROM installation it would not boot the phone. I tried following these instructions but the file is apparently...

I have had issues with my Patriot Pyro 120gb from the beginning. My system, more then occasionally freezes except that I can move my mouse, continue listening to music, etc, but I cannot open or close anything. My games on the SSD also experience huge lag spikes. The firmware version that is...