Recent content by mastering3d

HI I have push pull config in my system and have 3 of the Y adaptor so that i can use all six fans ,Which are 1500RPM but my problem here is this as you can see in the image one 3 pin plug only came with two wires on one side so i rewired that with another yellow that was missing on all 3...

Hi there i did look at another post on this forum but seeing as it was old ,I would ask in another topic on this . Ok i have the led working np on the switch and have that set as power light and hard drive active light . But then i get stuck with the powering up and down , I set the wires to...

Hi guys I have at the moment 5 1/4 x 2 Reservoir but i want to move to internal Reservoir . Which one is best to get with the 12V Laing DDC1+ Ultra 18W pump . was looking at this one XSPC Acrylic DDC Top but wanted to try and fan mount it to keep cool ? ..would that work or is there a better...

Hi Which is a better pump . 12V Laing DDC1+ Ultra 18W (MCP355) 12V Laing D5 Vario Pump (MCP655) thanks

Can any one tel me why the ThermoChill PA120.3, Some have bleed screw feature and some dont ? .. Thanks

Hi there guys . I am very upset to find that i can not get good temps off my CPU which is Q9550 rev.C1 . I did not know about this untill the other day when i was looking round and found out that there are two models or maybe more of this chip E0 & C1 and E0 being the better one for temps and...

Hi there guys . Just wondering if any of you guys can tel me where i can buy this block here in the Uk , I do have the EK block to fit to the 280gtx but i had bad time with that and the card got broken due to me ever not fitting it right or just a bad block . So I'm now looking for another...

Hi guys not sure if this is the right place on the forum to be asking this tbh , but ill ask away and see .I had a really cool site that was selling transparent perspects sheets ,But i cant remember the name of the site . So was wondering if you guys can help me out with a link to a really...