Recent content by jellybeard999

Is there anyone that could post all the settings from the BIOS of their NF4 Ultra/Sli when using ... Im venturing into the unknown with all the extra settings :( Life was so much simpler on the NF7-S :p (last time i had some really good ram, but was then limited to 227 by the chipset lol)

Anyone running / ran this on NF4 ? I have 2x512mb BH6, and another 2x512 is available to me, reckon its worth a try ? anyone get 1T ? or only 2T ??? I know some of you have tried this with UTT ... just wondering how it went :)

Setting up a raid array... and wonder what size stripe u guys use ? Ive tried 16k and get MUCH lower results in HDTach regarding average transfer rate than 32k , while burst and seek times are identical :s Im tempted to go back and redo 32k... Been trying to sort out nlite XP... hence i just...

http://www.pcpowercooling.com/products/viewproduct.php?show=T51XE that compatable with NF4 chipset boards you reckon ???

How noisy are these in comparison to : DD D4 (got atm - too noisy for me) DD D5 (what id get otherwise) :D Thanks

I have tried and failed to put SATA raid drivers in a windows install disc via nLite :( Can anyone go through each step (ie - nLite JUST SATA RAID drivers (DFI NF4 SLI-DR on Sil1334 say) i can do the slipstreaming etc... Do i press F6 when prompted ? or will my raid array just be there as if...

It will be fine to run a stock 7800GT with a maze4 on the core, but no ramsinks wont it ? At least till i get this HS cut up to use...

I have a vanilla X800 - 12pipes, 256mb DDR3, R430 Core Now, how would i go about this, without a bios flash ? I thought rivatuner, but alas not (least on the Cat 5.13) - can it on older drivers ? I also had an idea ATI tool can, but maybe not ??? I guess it must be a bios flash ?

Im setting up my HDDs in RAID0 (Sammys in sig) and wondered - what cluster size etc is best to use / do u use I want fast loading mainly... OS and games What do u recommend ? Any comparison charts for load times, transfer speeds etc ? Thanks

i hit a problem when installing my 4-1... The gasket was such that the mounting bolts had to go inside it, ie the neoprene is a square with square cut out... inside the cut out... so i just filled the holes with grease.... Is this correct ? I loaded up the dielectic grease, so am hoping...