Recent content by inspector-71

I am trying to go back a few firmwares to see if that helps with my temp issues but when I try and run bootloader, the compressor switches off for a second and then the pc shuts downs. I have not had any probs running bootloader before

this has come off my mach head http://picasaweb.google.co.uk/george.gornall/Prommie/photo#5054778186020286898 http://picasaweb.google.co.uk/george.gornall/Prommie/photo#5054778190315254210 will this cause me any problems? Can I just Glue it back on? could it be connected to what I am seeing...

When I switch my pc off a night I also switch it off at the wall (when the mach fans have cooled down) I mention this as I don't know if it is related. When I switch on at the wall and wait for the restart delay to complete the evap head is reported at anywhere between 5 and -15 degrees. Very...

Just a little note on my experience so far with this in case anyone is considering it fits standard mach to head, just. The caps round the socket are pretty close and you need to get seal string down there no probs with double reboots or anything like that board easily does 500fsb some ram...

what 965 boards take the standard mach 2 head without any modification?

my rig was working fine yesterday. i switched it on today and when I came back it hadn't started, the display read too slow and was reporting 55 degrees. I unplugged it and restarted and watched as it slowly went down to -1 but then stopped and reported "too slow" again I din't hear any of...

to ask for supplier referals other than extreme prometeia?

Thanks to everyone for their help and advice. I've posted it elsewhere so I'll just link to that

On papst 3 pin fans the wire colours are red, white, and blue. Which wire is the sensing wire? I want to leave this in the 3 pin and connect to a motherboard header so that I can monitor fan speed in mbm5. I want to put the power wires to my rheobus which uses screw terminals.

after about 6 weeks (since I don't get as much time as I used to with a 13 month old.) All eventually started coming together today Leak testing tomorrow!

for the lcd mainly and the usb. the rest i can lengthen myself but the lcd one looks a p.i.t.a.. if i lengthen the usb lead using unshielded wire will it be ok?

if I replace the rear 120mm fan with 2x180's and connect these to the controller board, will it still work ok or will the board show a fault?

my original plan with my v2000 mod was to support the condenser on a plastic box containing the control board. However, my psu is too long for this set up and the wires are too close to the prommie pipes. I have had to remove the dust filter panel at the front and push the condenser up against...

Now that I have removed the prommie fromt he original box and am installing it into a v2000, do I have to put the controller board in a plastic box to prevent it shorting out on the aluminium? Also, How do I disconnect the compressors live and neutral wires from the white thing on the board?

ok first phase mod so i removed the drive bays etc but now I have a problem... the hose is on the wrong side! when looking at the unit from the condenser, all the mods I have seen have the hose rising on the right, through the hole for the psu cables my stock unit has the hose rising on the...