OK so first job (and the hardest) was to remove the GPU. This was so I could get to the MB's USB sockets to add in the hub I got. Crap brand, but worked very well.
It didn't even need power connecting to it. Get out the second set.
And then slowly start adding them. This was extremely hard...
OK so yeah, today in a nut shell. Mask (this was a pain big time)
I put a fine line masked edge as I've never met a tape that doesn't bleed. Coat one.
You'll note the grille in the background.
Coat two.
Coat three.
And the grille.
Tomorrow I shall finally play with this toy...
OK so using scrap pink vinyl I made these.
I don't want the threads getting clogged. Would be very hard to tap, as they do not go through the wood. Any way, coat one of sealer.
Which as you can see was drying before I even took a pic. Second coat done.
I also bought some Dyna Mat...
Front badge done. Did get some glue on it (I hate super glue) and thought about maybe clear coating it. So to find out how it would look I used some clear lamination vinyl. I hated how it looked, so it can stay as it is.
Magnets are all glued onto their spacers now.
I then spent a couple...
What a two day willy pain. So I got over yesterday about 1. The rails were here waiting. However, when I went to fit them I noticed a big effing problem. The old rails were counter sunk into the front and rear panels. Meaning my new rails I just spent £25 on were too short. I then had the genius...
Seems it gets faster later in the evening. Must be because people are in town using the 5g in the day.
Bought a new switch. High end one this time. Might see if I can set up a VOIP or something when I am bored.