Aerocool Strike-X Air Review

tinytomlogan · #1 23-07-12, 09:19 AM

With it's bold and aggressive styling, the open frame design of Aerocool's Strike-X Air is aimed not just at gamers, but at those who like maximum access to their hardware.

Continue Reading

Danzle · #2 23-07-12, 06:50 PM

Hey, can i get a Corsair H100 or a Phanteks PH TC14PE whit a closed cover? Or can a H100 be installed?

airdeano · #3 24-07-12, 04:24 AM

thanks GDUB... when TTL introduced it at the show, it was a different something, just couldnt
wrap my head around it. but now, that you've shed a light on it, (or as well as you could be
cause of how large it was) it is different in a different way.

it doesn't look portible for a LAN case. it supports water cooling (grommets in the bulkhead) but
where to mount a radiator(s)? again, great review. told me what i need to know and how my
open benches are important without worrying about the top blowing off! LOL...

airdeano

G-Dubs · #4 24-07-12, 11:56 AM

@ Danzle. If you read the review you'll see I do mention that there is 230mm of space with the lid in the horizontal position so yes the 171mm tall phantek wil fit. With the lid fully closed however I doubt it. H100 wise, there are mounting holes on the bar that runs above the PCI rear I?O area for attaching a rad, however if you went for a 120.2 like the H100 you're going to have to think hard about where your PCI cables exit etc so's you don't go and obstruct them with the rad.

@ Airdeano. Please see above re rad mounting holes and page 2 para5 of the review.

theteebox · #5 20-11-12, 04:03 AM

Almost PERFECT! Except for this one : it might slower you SATA III 6Gbit/s transfer rate. also don't know either it using SATA Revision 3.1 or not.. wasting on my SSD

SnW · #6 20-11-12, 10:20 AM

I decited to go for this one (in regards to my Folding/Bench table thread),
seems to have all the things i need and pretty cheap as well,

Thanks for the review Gary Wain (bit late)

Greetings, Ray......

theteebox · #7 20-11-12, 10:44 AM

Quote:

Originally Posted by theteebox

Almost PERFECT! Except for this one : it might slower you SATA III 6Gbit/s transfer rate. also don't know either it using SATA Revision 3.1 or not.. wasting on my SSD

or.. just swap the data files