Go Back   Overclock3D Forums > [OC3D] Hardware & Software > New Build Advice
Reply
 
Thread Tools Display Modes
 
  #1  
Old 08-10-09, 10:42 PM
mastering3d mastering3d is offline
Newbie
 
Join Date: Aug 2009
Posts: 40
3 Pin Y adaptor

HI

I have push pull config in my system and have 3 of the Y adaptor so that i can use all six fans ,Which are 1500RPM but my problem here is this as you can see in the image one 3 pin plug only came with two wires on one side so i rewired that with another yellow that was missing on all 3 sets ,But when all is pluged in the pc and running on the fan control i am only getting 1350rpm ,

Why would the speed drop like that any idea ? ..

Thanks

Reply With Quote
  #2  
Old 08-10-09, 10:46 PM
PeterStoba PeterStoba is offline
OC3D Elite
 
Join Date: Feb 2009
Posts: 1,190
Two fans off one channel only needs one yellow RPM sensor wire.
__________________
Silverstone SG05B | i3 530 | Scythe Shuriken | DFI LanParty MI P55-T36 | 4GB Kingston HyperX 1333Mhz | XFX 5450 512MB | Samsung SN-T083C | Intel X25-V 40GB | Samsung F1 1TB

LGW2452TX-PF | Logitech G9 | Logitech G15 | Logitech Z5500

Reply With Quote
  #3  
Old 08-10-09, 10:56 PM
mastering3d mastering3d is offline
Newbie
 
Join Date: Aug 2009
Posts: 40
i see ok thanks for clearing that up for me so if i take the wire back off i should get full speed again .
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump






All times are GMT. The time now is 02:16 PM.
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.